Get Jump Start Services Buffalo NY

By Janet Stone


There are several reasons that can results to your vehicle not starting. The engine may fail to crank over if the battery is dead or discharged. When the headlights dim severely or go out as you try to crank the engine, the battery could be discharged. But when the headlights do not come at all as you try to crank the engine, the battery could be completely dead. In this case, your best option is to get jump start services Buffalo NY.

The first thing you should do before you consider jump-starting your car is to check that all the battery connections are okay. Sometimes the battery could be okay but a poor connection can make your vehicle not start or the headlights fail to come on. You can also check on the battery voltage if you are in a position to do so.

If the battery is discharged, you should not jump start it. The best thing to do in such a scenario is to recharge it with a battery charger. Jump-starting a discharged battery can lead to more damage on your vehicle than you may think. Most of the new vehicle models have very many electronic components. These can easily get damaged by a voltage spike. Voltage spikes can occur where there is a loose connection on the battery or with a discharged battery. This is why it is important that you check the connections before you consider jump- starting.

Never attempt to jump-start a vehicle when it is freezing outside. The battery could be frozen as well. Jump-starting such a battery could cause it to explode. If your car is computer controlled, the best thing to do if your battery is dead is to remove it and charge it. Jump-starting is not advised. However, if you attempt to jump start, ensure the ignition is off on both vehicles as you make the connections. The two vehicles should also not be touching or they may provide an unwanted ground path.

Some vehicles provide special instructions to any jump-starting event. These instructions are provided for in the service information. You should have a look at this before you start. They can prevent you from causing damage to your vehicle. Always protect yourself from any injury by following all safety procedures.

The best jump start cables to use are those that are flexible, large in size and do not overheat. Braided copper cables are usually of good quality. Aluminum jump start cables are small and tend to overheat. They can easily burn you if you are not careful.

You should wear eye protection when jump-starting a vehicle. You need to be more careful when connecting the last cable to the dead battery. There may be sparks created as the cable is connected to the battery and this can harm your eyes.

If you are unsure about how to connect the cables, leave it to an expert of a more experienced and knowledgeable person. A wrong connection can damage the entire electrical system of your car. Hot cables are usually connected first and the ground cables last. After the vehicle starts, they are disconnected immediately starting with the ground cables.




About the Author: